Memory BAT mapping: BAT2=256Mb, BAT3=256Mb, residual: 0Mb Total memory = 512MB; using 2048kB for hash table (at c0400000) Linux version 2.4.19-pre7-ben0-moe0 (jebba@yaxchilan.themoes.org) (gcc version 2.95.4 20010319 (prerelease/franzo/20011204)) #1 Sat May 11 18:26:00 BST 2002 Found Uninorth memory controller & host bridge, revision: 17 Found a Keylargo mac-io controller, rev: 3, mapped at 0xfde8f000 Processor NAP mode on idle enabled. PowerMac motherboard: PowerBook Titanium II Found UniNorth PCI host bridge at 0xf0000000. Firmware bus number: 0->0 hose pci, pci_mem_offset: 00000000, start0: f1000000 io_base_virt: fd68c000, io_base_phys: f0000000, isa_mem_base: 00000000 Found UniNorth PCI host bridge at 0xf2000000. Firmware bus number: 0->1 hose pci, pci_mem_offset: 00000000, start0: f3000000 io_base_virt: fce8a000, io_base_phys: f2000000, isa_mem_base: 00000000 Found UniNorth PCI host bridge at 0xf4000000. Firmware bus number: 0->0 hose pci, pci_mem_offset: 00000000, start0: f5000000 io_base_virt: fc688000, io_base_phys: f4000000, isa_mem_base: 00000000 PMU driver 2 initialized for Core99, firmware: 0c On node 0 totalpages: 131072 zone(0): 131072 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: root=/dev/hda12 hdc=ide-scsi ide_setup: hdc=ide-scsi PowerMac using OpenPIC irq controller OpenPIC Version 1.2 (4 CPUs and 64 IRQ sources) at fc641000 OpenPIC timer frequency is 4.166666 MHz GMT Delta read from XPRAM: 60 minutes, DST: on time_init: decrementer frequency = 33.290001 MHz Console: colour dummy device 80x25 Calibrating delay loop... 665.19 BogoMIPS Memory: 513064k available (1864k kernel code, 824k data, 264k init, 0k highmem) AGP special page: 0xdffff000 Dentry-cache hash table entries: 65536 (order: 7, 524288 bytes) Inode-cache hash table entries: 32768 (order: 6, 262144 bytes) Mount-cache hash table entries: 8192 (order: 4, 65536 bytes) Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes) Page-cache hash table entries: 131072 (order: 7, 524288 bytes) POSIX conformance testing by UNIFIX PCI: Probing PCI hardware Fixup res 1 (101) of dev 00:10.0: 400 -> 802400 Can't get bus-range for /pci@f2000000/cardbus@1a PCI->OF bus map: 0 -> 0 1 -> 0 6 -> 0 PCI:00:10.0: Resource 0: b8000000-bfffffff (f=1208) PCI:00:10.0: Resource 2: b0000000-b000ffff (f=200) PCI:01:17.0: Resource 0: 80000000-8007ffff (f=200) PCI:01:1a.0: Resource 0: a0000000-a0000fff (f=200) PCI:06:0f.0: Resource 0: f5200000-f53fffff (f=200) PCI:00:10.0: Resource 1: 00802400-008024ff (f=101) PCI:01:18.0: Resource 0: a0002000-a0002fff (f=200) PCI:01:19.0: Resource 0: a0001000-a0001fff (f=200) PCI:06:0e.0: Resource 0: f5000000-f5000fff (f=200) Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Thermal assist unit using timers, shrink_timer: 200 jiffies Starting kswapd Journalled Block Device driver loaded udf: registering filesystem PCI: Enabling device 00:10.0 (0086 -> 0087) radeonfb: ref_clk=2700, ref_div=12, xclk=16615 from OF radeonfb: detected DFP panel size from registers: 1152x768 Console: switching to colour frame buffer device 144x48 Registered "ati" backlight controller, level: 1/15 radeonfb: pm reg @50, clk_pwrmgt: 13400, pll_pwrmgt: 1000007, mdll_cko: 43c radeonfb: ATI Radeon M6 LY DDR SGRAM 16 MB radeonfb: DVI port LCD monitor connected radeonfb: CRT port no monitor connected no framebuffer address found for /pci@f0000000/ATY,StoneParent@10/ATY,Stone_B input0: Macintosh mouse button emulation pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled IN from bad port 3f9 at c00cc758 IN from bad port 3f9 at c00cc758 IN from bad port 3f9 at c00cc758 IN from bad port 2f9 at c00cc758 IN from bad port 2f9 at c00cc758 IN from bad port 2f9 at c00cc758 IN from bad port 3e9 at c00cc758 IN from bad port 3e9 at c00cc758 IN from bad port 3e9 at c00cc758 IN from bad port 2e9 at c00cc758 IN from bad port 2e9 at c00cc758 IN from bad port 2e9 at c00cc758 Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx pmac_ide: enabling IDE bus ID 2 pmac_ide: enabling IDE bus ID 0 pmac_ide: enabling IDE bus ID 1 hda: TOSHIBA MK3017GAS, ATA DISK drive hdc: MATSHITACD-RW CW-8121, ATAPI CD/DVD-ROM drive ide0 at 0xe5255000-0xe5255007,0xe5255160 on irq 19 ide1 at 0xe5259000-0xe5259007,0xe5259160 on irq 20 hda: Enabling Ultra DMA 4 ide_pmac: Set UDMA timing for mode 4, reg: 0x0c50038c hda: 58605120 sectors (30006 MB), CHS=58140/16/63, UDMA(66) hdc: Enabling MultiWord DMA 2 ide_pmac: MDMA, cycleTime: 120, accessTime: 90, recTime: 30 ide_pmac: Set MDMA timing for mode 2, reg: 0x00011d26 Partition check: hda: [mac] hda1 hda2 hda3 hda4 hda5 hda6 hda7 hda8 hda9 hda10 hda11 hda12 RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) sungem.c:v0.97 3/20/02 David S. Miller (davem@redhat.com) eth%d: MII PHY ID: 1410c60 M1011 (Marvel ?) eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:03:93:66:70:76 Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 440M agpgart: Detected Apple UniNorth 1.5 chipset agp: configuring for size idx: 4 agpgart: AGP aperture is 16M @ 0x0 [drm] AGP 0.99 on Unknown @ 0x00000000 16MB [drm] Initialized radeon 1.1.1 20010405 on minor 0 SCSI subsystem driver Revision: 1.00 scsi0 : SCSI host adapter emulation for IDE ATAPI devices Vendor: MATSHITA Model: CD-RW CW-8121 Rev: AA11 Type: CD-ROM ANSI SCSI revision: 02 Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0 sr0: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray Uniform CD-ROM driver Revision: 3.12 Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] [pm] PowerMac Z8530 serial driver version 2.0 tty00 at 0xe22f3020 (irq = 22) is a Z8530 ESCC tty01 at 0xe22fa000 (irq = 23) is a Z8530 ESCC (IrDA) Macintosh non-volatile memory driver v1.0 apm_emu: APM Emulation 0.5 initialized. usb.c: registered new driver usbdevfs usb.c: registered new driver hub PCI: Enabling device 01:18.0 (0000 -> 0002) usb-ohci.c: USB OHCI at membase 0xe2300000, IRQ 27 usb-ohci.c: usb-01:18.0, Apple Computer Inc. KeyLargo USB Yenta IRQ list 0000, PCI irq58 Socket status: 30000086 adb: starting probe task... usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected PCI: Enabling device 01:19.0 (0000 -> 0002) usb-ohci.c: USB OHCI at membase 0xe2302000, IRQ 28 usb-ohci.c: usb-01:19.0, Apple Computer Inc. KeyLargo USB (#2) usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected usb.c: registered new driver hid hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers mice: PS/2 mouse device common for all mice NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 131072 bind 65536) ip_conntrack (4096 buckets, 32768 max) ip_tables: (C) 2000-2002 Netfilter core team NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: AppleTalk 0.18a for Linux NET4.0 adb devices: [2]: 2 c4 [3]: 3 1 [7]: 7 1f ADB keyboard at 2, handler 1 Detected ADB keyboard, type ISO, swapping keys. input1: ADB HID on ID 2:2.c4 input2: ADB HID on ID 7:7.1f ADB mouse at 3, handler set to 4 (trackpad) input3: ADB HID on ID 3:3.01 adb: finished probe task... kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 264k init 8k chrp 8k prep Adding Swap: 524280k swap-space (priority -1) EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,12), internal journal kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,10), internal journal EXT3-fs: mounted filesystem with ordered data mode.